Boiler Compound – 1 (Interior)

Product Scope

Buxly Boiler Compound – 1 is an anti-corrosive coating for internal surfaces of boiler drums in contact with hot water. It resists heat up to 550°C. It can be used for condensers, air coolers, water tanks (not for drinking), centrifugal pumps, boiler drums, chimneys, structural steel, ducting etc.

Product Application

Normally no separate primer is necessary. Apply at least two coats of Buxly Boiler Compound–1 by brush, working first coat well into surface. Do not apply heavy coats. It is advisable to allow 24 hours between coats and a minimum 24 hours after complete application to allow system to harden. Adequate ventilation must be provided at all times.

Technical Information

Type Single Pack
Composition Inert pigments in bitumen solution
Application Brush
Drying Time a) Surface Dry : 5 – 8 Hours (at room temperature)
b) Hard Dry : 18 – 24 Hours (at room temperature)
c) Recoat : 24 Hours
Theoretical Spreading Rate 15.5 m2 per Liter
Dry Film Thickness 35 + 5 microns per coat
Number of Coats 2 Coats Minimum
Finish Matt
Volume Solids 55 + 2 %
Heat Resistance Up to 550OC
Thinner Buxly’s Mixing Thinner if required
Packing 5 Liters pack size
Storage Stability One year when stored properly in original sealed container at 15 to 35°C

Buxly Paints Limited

Commitment to Excellence in Quality

Data Sheet Get Quote