Chlorinated Rubber Road Marking Paint

Product Scope

Buxly C.R. Based Road/Airfield Paint Marking has over the past many years proven itself on roads and highways all over Pakistan. Mainly due to its faster drying properties, its application is easy, adhesion to bituminous/asphaltic roads, abrasion and weather resistance is very good. The dirt pick-up of Buxly’s C.R. Road Marking is less, and markings reappear as clean marking after rain or washing with water.

Product Application

Applicable to old and new roads, runways and concrete surfaces.

Technical Information

Type Single pack
Colors Golden Yellow, White & Black
Composition Pigments, Resins, Additives, Aromatic Hydrocarbons and solvents
Application Brush/Roller/Road Lining Automatic Spray Machine
Drying Time a) Surface Dry : 5-15 Minutes (Depending on weather)
b) Re-coat : 30 Minutes to 1 Hour
c) Hard Dry : 1 ½ to 2 Hours
Average Spreading Rate 8–10 m2 per liter @ D.F.T. 30-35 microns
Dry Film Thickness 100 + 10 Microns by Lining Spray Machine
30 + 5 Microns by brush/roller
Number of Coats Normally one coat on previously marked old surfaces is sufficient to give adequately visible marking. On new roads, usually two coats are applied
Finish Smooth, Egg Shell to Matt
Volume Solid 70 + 2 %
Primer On very porous roads/runways a priming coat is advisable to fill to a certain extent the irregular surface profile
Thinner Buxly’s CR Thinner
Packing 4 and 20 Liters pack sizes
Storage Stability Six month when stored properly, in original sealed container at 15 to 35°C

Buxly Paints Limited

Commitment to Excellence in Quality

Data Sheet Get Quote