Boiler Compound – 3 (Exterior)

Product Scope

Buxly Boiler Compound – 3 is specially recommended for exterior surfaces of boiler which are exposed to indirect dry heating to maximum 250°C. It can be applied on exterior surfaces of boilers, chimneys, air coolers, condensers etc.

Product Application

No separate primer is necessary. Apply first coat (direct to clean steel) and work well into the surface and ensure all corners, edges, welds, nuts/bolts are covered. Do not apply a thick coat. Allow minimum interval of 16 – 18 hours before applying second coat. Subsequent coat may be applied by brush or roller.

Technical Information

Type Single Pack
Composition Blend of inert bitumen and solvent
Application Brush/Roller
Drying Time a) Surface Dry : One Hour
b) Hard Dry : Four Hours
c) Recoat : 16 – 18 Hours (at room temperature)
Theoretical Spreading Rate 16.5 m2 per Liter
Dry Film Thickness 30 + 5 Microns per coat
Number of Coats 2 Coats Minimum
Finish Matt
Volume Solids 50 + 2 %
Heat Resistance Fully cured film resists up to 250°C dry heat
Thinner Buxly’s Mixing Thinner if required
Packing 5 Liters pack size
Storage Stability One year when stored properly in original sealed container at 15 to 35°C

Buxly Paints Limited

Commitment to Excellence in Quality

Data Sheet Get Quote